Of wobbly wheels an...
 
Notifications
Clear all

Of wobbly wheels and castle nuts...

4 Posts
4 Users
0 Reactions
57 Views
(@joekolinski)
Active Member
Joined: 2 years ago
Posts: 5
Topic starter   [#48]

I got my 1977 MGB inspected last month (I passed), but the inspector noted that the left front wheel was "loose" (side to side, not up and down).  What would be the way to determine whether it's simply a loose castle nut that needs to be tightened or whether it's a larger issue with the wheel bearings?  The car has < 79k miles, so I wouldn't think it would be the bearings, but I defer to others who have more experience.

Thanks as always.



   
Quote
(@fredmrichards)
Active Member
Joined: 5 years ago
Posts: 8
 

My 78 Spitfire needed new bearings at 76K, it is not that difficult to do. The challenge was getting the Castle nut right.

the wheels could be rocked side to side and top to bottom.



   
ReplyQuote
(@dtschuder)
Active Member
Joined: 4 years ago
Posts: 7
 

A properly installed castle nut should not come loose as long as the cotter pin is in place. For proper installation: 1. Tighten to the specified torque. 2. Check to see if one of the slots in the nut is aligned with the hole in the shaft. 3. If so, install and secure the cotter pin. 4. If no slot is aligned with the hole, tighten no more than one face on the nut as needed to achieve proper alignment and install the cotter pin. If the alignment is very close after initial torquing and backing off slightly will allow tor proper alignment - that's OK.

With all of that said, I'd check that castle nut before considering bearing replacement. 



   
ReplyQuote
(@66typ26)
Trusted Member
Joined: 4 years ago
Posts: 28
 

IMO: Slightly worn bearings can be compensated for by re-torquing the nut.  I seem to recall that this was observed on another MGB during a Tech Squad session some time ago.  It does not hurt to check the torque on the nut anyway.  However, for bearings, the wobble’ should be observed in all directions.

A ‘side-to-side only’ wobble leads me toward suspecting a worn tie rod end.  Even if it was replaced, I’ve heard poor quality can lead to premature failure.  A replacement control arm/tie rod on my wife’s 2013 Mercedes lasted less than 20k miles.  The original lasted 90k!


This post was modified 5 days ago by Jon Piquette

   
ReplyQuote