Notifications
Clear all

Cable lubrication for e-brake, manual choke, heater control valve, and more!

1 Posts
1 Users
0 Reactions
62 Views
(@66typ26)
Trusted Member
Joined: 4 years ago
Posts: 28
Topic starter   [#47]

High quality cables for bicycles have incorporated a teflon inner sleeve for many years.  Unfortunately, most Automotive cables just have bare stainless steel cables running in a stainless steel housing coated with vinyl on the outside. Cheap, but effective. A “Cable Luber” is a handy tool for keeping cables lubricated.  A Cable Luber has a rubber sleeve, slit lengthwise and two thumbscrews.  The tool slips over the bare cable. One end of the Luber seals the end of the cable housing, while the other seals the cable.  Tighten the thumbscrews to seal the tool.  Tip: Tighten one screw a full turn and then the other, alternating until the clamp is fully engaged.  The tool has injection ports for your favorite spray lubricant (graphite, silicone, teflon, WD40, etc).  For best results: Keep spraying until the lubricant exits the other end of the cable.  If any spray comes out of the tool, loosen the clamps and reposition the tool to get a better seal.  Cable Lubers are readily available at bicycle shops, or on your favorite online shopping sites (Amazon, eBay, etc).  Note: these Cable Lubers work on the cables on your lawnmowers and snowblowers too!



   
Quote